Accessories for your Simulyzer
Simulyzer
Connector Box
Connect sensors and ECUs with ease. The Connector Box brings your Simulyzer signals to accessible 4 mm banana sockets.
- For PSI5, DSI3 and SENT Simulyzers
- Passive adapter with no separate power supply
- Two ribbon cables included
Clear connections
From Simulyzer to banana socket
The Connector Box routes the Sensor/ECU IO connector to ten labelled binding posts. Connect sensors, the ECU and ground leads using suitable 4 mm banana plugs.
- GND
- Signal ground
- ECU1 / ECU2
- ECU connection for PSI5/DSI3;
positive supply for SENT - Sensor1 / Sensor2
- Sensor connection for PSI5/DSI3;
data line for SENT - DC1 / DC2
- Daisy-chain connection;
not used for SENT
The available channels depend on the Simulyzer and operating mode. The DSI3 Simulyzer uses the first signal channel; the second row of terminals does not provide an additional DSI3 channel.
To the Simulyzer
Use a supplied ribbon cable to connect the 25-pin D-sub socket to the Simulyzer’s Sensor/ECU IO connector.
For daisy-chain setups
The 25-pin External connector provides an onward connection when required. Leave it unconnected when no daisy-chain connection is needed.
Disconnect power from the test setup before changing any wiring. Refer to the operating instructions for the box and the respective Simulyzer for pin assignments and permissible signal levels.
Compact accessory
One box. Two cables. Clear connections.
A robust aluminium housing, accessible terminals and matching ribbon cables. The box requires no software installation. Your Simulyzer handles measurement, simulation and configuration.
- Order number
- 9.0002
- Compatibility
- PSI5, DSI3 and SENT Simulyzers
- Lab connections
- 10 binding posts with 4 mm banana sockets
- Dimensions
- 120 × 78 × 43 mm
- Housing / weight
- Aluminium / 0.320 kg
Knowledge & support
The instructions, ready to hand
Terminal assignments, setup and technical data – available as a PDF in your preferred language.
