Generate a sequence.
Change the desired value by clicking in the according line of the table. The changed values will be changed immediately by leaving the entry.
Modify a generated sequences
After the sequence is generated with its edge data, the further definition resp. modifications of the data can be done.
|
Address |
Consecutive number |
| Sequence |
Complete sequence in hex format |
|
Out |
Signal state |
|
Data |
Time of the impulse (Bit width *Bit time*2) |
|
Delay |
Impulse delay in µs. |
|
CMD |
- |
| Procedure | |
|
|
Generate a sequence. |
|
|
Change the desired value by clicking in the according line of the table. The changed values will be changed immediately by leaving the entry. |